Nouryon Levasil: Colloidal Silica Product Range and Applications

Published: Source: Silica Raw Materials News Section: Silica Raw Materials

📌 Key Takeaways

  • Topic: Silica as a Carrier: Converting Liquids into Free-Flowing Powders
  • Keywords: ultrafine silica powder
  • Published: 2026-11-20 05:09:22
  • Field: Silica (SiO₂) raw materials · Inorganic non-metallic materials · Chemicals
By connecting different functional groups, smaller or larger changes can be observed in the surface charge (zeta potential values) and hydrophilicity/hydrophobicity of SNPs [ 14, 18 ]. Such functional groups can be, for instance, -NH 2, -PO 3, -SH, -COOH, and -CH 3 [ 14, 18 ]. By functionalizing the internal surface (pores), the drug loading and the stability of the molecules can be raised, the release kinetics can be influenced, and even controlled release can be created [ 2, 18, 27 ]. By functionalizing the outer surface, the stability and biocompatibility of the particles can be improved [ 2, 27 ]. The outer surface also affects the interactions with the cell membrane, cellular uptake, and penetration [ 2, 12, 18, 27, 28 ], and lets the creation of cell-specific targeted therapy [ 2, 27 ]. The hydrophilic/neutral surface favors permeability through the mucus hurdle, while the hydrophobic/cationic surface promotes penetration through epithelial cells [ 12, 18 ]. Cationic nanoparticles have a higher degree of internalization than anionic particles [ 18, 28 ]. Positively charged functional groups (-NH 2 ) can establish electrostatic interactions with the negatively charged cell membrane, leading to raised endocytosis compared to negatively charged groups (-SH) [ 18, 28 ]. SNPs also have permeation-enhancing properties as they can temporarily open epithelial tight junctions owing to their size and surface, thereby increasing the drug absorption [ 13, 14 ]. SNPs smaller than 200 nm with a negative surface charge have this property [ 13 ], while particles with a positive or neutral surface do not show similar effects [ 13 ].

Silica for Powder Coatings: Flow Aid, Matting and Anti-Caking Functions

Silica Gel Beads: Types, Sizes, Indicating vs Non-Indicating and Uses
Silica Surface Area Explained: Typical BET Values by Type and Why It Matters
Utilizing DE as a Pesticide
Silica Distributor vs Manufacturer: Which Is Better for Your Purchase?
Silica as an Insulating Filler: Dielectric Properties and Electronic Uses
Even though MSNs can usually be recognized as secure products, their use during therapy may cause side impacts in the body [ 1, 2, 29 ]. Due to their small size and large surface area, they may tend to accumulate in the body, or certain organs (liver, spleen, kidney, lung) and may even be toxic in higher concentrations, which is a clear disadvantage [ 1, 4, 27 ]. The silanol groups (Si-OH) on their surface can interact with the phospholipid layer of the cell membrane, thereby causing cell lysis or, in extreme cases, hemolysis [ 4, 8 ]. In severe cases, the lack of hemocompatibility can also cause issues [ 2 ]. Overall, indications of cytotoxicity, haemotoxicity, and genotoxicity were also found [ 4, 8 ]. That is why the biocompatibility of all comparable preparations must be strictly controlled [ 2, 4, 27 ]. The physicochemical features (particle size, particle morphology, surface chemistry, pore structure, etc.) of nanocarriers also have a major impact on toxicity [ 2, 4, 8, 30 ]. Additionally, further attention must be paid to the biological influences of their decomposition products, because they may also cause unwanted side influences [ 1 ]. The breakdown of silica nanoparticles in the body can take up to a few days. The opening hydration is followed by hydrolysis, and, in the end, they are excreted in the urine in the form of silicic acid [ 1 ]. Nevertheless, the literature is contradictory in this regard [ 31 ]. Some experiments show no considerable cytotoxic effect [ 18, 31 ], while other experiments say otherwise [ 23, 32 ]. For example, an in vitro study was performed with multiple concentrations, surfaces, and particle sizes (60 nm, 100 nm, 300 nm) of MSNs, with an exposure time of 72 h [ 18 ]. This study shown no significant cytotoxic influence in any of the cell lines tested (human cervical (HeLA), epithelial lung (A549), and glioblastoma (U251)) [ 18 ]. Ismail et al. investigated the cytotoxic effect of silica nanoparticles in vivo in mouse models [ 33 ]. Amorphous silica nanoparticles were administered to the animals orally, at a dose of 150 mg/kg/day, for 3 months. Based on these mouse models, no toxic effects were detected under sub-chronic treatment of the nanoparticles [ 31 ]. In another study, particle size (15 nm, 60 nm, 200 nm) dependent impact was observed on cellular viability in all four cell lines tested (THP-1 derived macrophages, A549 epithelial cells, HaCaT keratinocytes, and NRK-52E kidney cells) [ 23 ]. Smaller particles caused notable toxicity on each cell line, after the exposure time of 24 h, in contrast to the larger particles, which demonstrated no cytotoxic impact [ 23 ]. A comparable outcome has been published to verify the toxic characteristic of mesoporous silica. In this in vitro study, the researchers investigated the effect of MSNs with an average size of 7 nm on cell viability at three different concentrations. After 72 h of exposure, only the highest concentration (62.5 µg/mL) caused a substantial decrease in cell viability of human lung fibroblast cells. This toxicity occurred in a time- and dose-dependent manner [ 32 ]. In an in vivo mouse model, MacCuaig et al. presented coating-dependent impacts after repeated intravenous administration of MSNs. Chitosan-coated MSNs induced minor organ changes and were the most biocompatible. Uncoated and especially PEG-coated MSNs (especially 2K PEG) moderately augmented pre-existing vascular or organ lesions, implying that PEGylation has the potential to augment chronic risks, while chitosan enables safer long-term use [ 34 ]. An in vitro study of Barguilla et al. exposed epithelial lung cells to bare, PEG-functionalized, or galacto-oligosaccharide-functionalized MSNs for eight weeks. There was no reported long-term DNA damage, but malignant-like alterations like anchorage-independent growth, boosted migration/invasion, and secretome-facilitated tumor promotion were triggered by PEG- and GAL-functionalized MSNs. Naked MSNs did not cause such alterations and were determined to be safer [ 35 ]. Coating, on the whole, exerts a significant impact on the safety of MSNs. Uncoated MSNs are relatively innocuous; the most biocompatible coatings were achieved with chitosan, but PEG and carbohydrate functionalization can be dangerous in the long run, from vascular toxicity in vivo to tumor-promoting activity in vitro [ 34, 35 ].

Alkaline Silica Sol: Properties, pH Range and Industrial Uses

What is silica (SiO₂)?

silica supplier Russia Food Grade DE is a fairly distinctive mineral in that it can be used to fill a really diverse range of needs. In a broad sense, nearly all uses fall into two principal (and rather unrelated) categories: health advantages and pest control. If you've purchased food grade diatomaceous earth, chances are you're looking for some health improvements for family or pets, or you're attempting to handle pests like bedbugs in and around the home.

What is the difference between fumed silica and precipitated silica?

scratch resistant silica Filling the pores with an API can be solved in several ways, which can be classified into two main groups: organic solvent-free and organic solvent-based techniques [ 36, 37 ]. The percentages of entrapment efficiency (EE%) and drug loading (DL%) are calculated based on the following equations (Equations (1) and (2)) [ 11, 38, 39, 40, 41 ].

What drives silica raw material prices?

monodisperse silica spheres

Cite this article: Silica Raw Materials News. "Fumed Silica Brands Compared: Aerosil, Cab-O-Sil, HDK and Chinese Alternatives ." Published 2026-11-20 05:09:22. /news/article.html
Disclaimer: Prices and data are for reference only and do not constitute purchasing or investment advice. Please credit the source when republishing.