Evonik Aerosil: Product Range, Key Grades and Equivalent Alternatives

Published: Source: Silica Raw Materials News Section: Silica Raw Materials

📌 Key Takeaways

  • Topic: What Is the Molar Mass of Silicon Dioxide (SiO₂)? Calculation Explained
  • Keywords: fused silica CAS 60676-86-0
  • Published: 2026-11-19 02:23:40
  • Field: Silica (SiO₂) raw materials · Inorganic non-metallic materials · Chemicals

Silica Antiblocking Agent: How It Works, Particle Size Selection and Uses

Silica Distributor vs Manufacturer: Which Is Better for Your Purchase?
One of the biggest challenges of tableting greatly potent APIs (antibiotics, hormones, cytostatic molecules) is to attain content uniformity [ 95, 96 ]. Since these molecules are used in small doses, it is demanding to attain a homogeneous powder mixture during mixing and to make sure this homogeneity until the end of tableting. Also, it is a hurdle to develop a reproducible method that ensures content uniformity for each production batch, since the specified dose must be made sure between batches, not just within one batch [ 95, 96 ]. A reliable alternative method is to use mesoporous silica as a carrier system rather than simple powder mixing, thus preventing the segregation and aggregation of the low-dose API during mixing and compression. In this case, the preloaded mesoporous carrier and the necessary excipients are mixed, and then the powder mixture can be compressed directly or after granulation. The drug loading can be controlled by the concentration of the drug solution used to fill the carrier systems, which affects the amount of the drug content in the concluding medicine [ 95, 96 ]. Based on this, nearly unlimitedly low doses can be formulated into tablets, even in a concentration of 0.01%, just by properly preparing the solution [ 96 ]. The technique is well-controllable and dependable, since each tablet has the same drug content and the desired content uniformity. Furthermore, the method can be used in both batch-based and continuous production [ 96 ]. This may be a promising finding because there is evidence that it is challenging to move from batch-based to continuous manufacturing while maintaining the desired drug content and content uniformity [ 94 ]. But it should be noted that in this study, no nanocarrier system was used [ 94 ], so utilizing MSN formulations could make an enormous improvement in developing continuous tablet manufacturing [ 96 ]. A study shown that MSN carriers can also be used in orodispersible films to enhance the dissolution of poorly water-soluble drugs [ 100 ]. Based on in vitro drug release studies, more than 90% of prednisolone was released within 2 min when the loaded MSN was incorporated into the formulation. This means a much faster, immediate release in comparison with formulations containing the free form of the drug. In addition, precise dosing can be accomplished utilizing nanocarriers for personalized medication; furthermore, enabling the production of low-dose preparations without content uniformity problems [ 100 ].
Best Silica Supplier: How to Choose in 2026 (Checklist and Comparison Criteria)
The size of the particles greatly affects the interaction with epithelial cells, cellular absorption, and therefore their effectiveness [ 1, 10, 12 ]. Furthermore, the size also influences the leakage of the API [ 12 ]. It has been proven in vitro that epithelial permeability can be increased by decreasing the size [ 1, 12, 13, 24 ]. Zhang et al. also observed that the cellular uptake of MSNs occurred in a time-, concentration-, and size-dependent manner based on in vitro studies performed on Caco-2 cell lines (20 nm, 60 nm, 90 nm) [ 24 ]. Nevertheless, more complex findings were gained in vivo. Wang et al. compared differently sized nanoparticles in various elements (100 nm, 250 nm, 480 nm) [ 12 ]. Similarly, Lamson et al. compared MSNs with different sizes to observe the influence of the particle size on bioavailability (20-1200 nm) [ 13 ]. Larger particles (normally around 500 nm) show slower release of the API and can form a strong interaction with the cell membrane [ 12 ], but cellular uptake is limited owing to their large size [ 1, 12 ]. Smaller particles (below 100 nm) show weaker interaction with the cell membrane but exert superb cellular uptake owing to their small size [ 12 ]. On the other hand, the smaller particles can slowly diffuse through the mucin layer covering the surface of the intestinal mucosa, become trapped in it, and aggregate, further worsening the absorption [ 1, 12, 13 ]. Furthermore, the decreasing particle size leads to increased release rate, owing to the larger specific surface area and faster degradation of the particles [ 1, 12 ], which can lead to early leakage of the molecules, worsening their absorption [ 1, 12 ]. As the diameter increases, the rate of degradation and drug release kinetics decreases, so larger particles have a longer half-life [ 12 ].
Silica Aerogel Powder: Properties, Applications and How It Compares to Other Insulators
25. Janjua T.I., Cao Y., Kleitz F., Linden M., Yu C., Popat A. Silica nanoparticles: A review of their safety and current strategies to overcome biological barriers. Adv. Drug Deliv. Rev. 2023;203:115115. doi: 10.1016/j.addr.2023.115115. [ DOI ] [ PubMed ] [ Google Scholar ]
Silicon Dioxide in Food: Why It Is Added and Whether It Is Safe
In the case of melt granulation, it is necessary to use meltable excipients that can melt at low temperatures (50-90 °C) as a binder [ 98, 108 ]. The molten binder forms the agglomerates during cooling and solidification. Since it does not need a liquid binder, it is advantageous for use in the case of moisture-sensitive molecules. However, its use should be avoided for heat-sensitive materials.

Silica Mesh Size Chart: Mesh to Micron Conversion and How to Choose

What is silica (SiO₂)?

silica for printing ink So why make a website dedicated to some fossilized deposit?

What is the difference between fumed silica and precipitated silica?

silica for sealants 34. MacCuaig W.M., Samykutty A., Foote J., Luo W., Filatenkov A., Li M., Houchen C., Grizzle W.E., McNally L.R. Toxicity Assessment of Mesoporous Silica Nanoparticles upon Intravenous Injection in Mice: Implications for Drug Delivery. Pharmaceutics. 2022;14:969. doi: 10.3390/pharmaceutics14050969. [ DOI ] [ PMC free piece ] [ PubMed ] [ Google Scholar ]

What drives silica raw material prices?

silica anti caking agent

Cite this article: Silica Raw Materials News. "Fumed Silica CAS 112945-52-5: Identification, Properties and Safety Data ." Published 2026-11-19 02:23:40. /news/article.html
Disclaimer: Prices and data are for reference only and do not constitute purchasing or investment advice. Please credit the source when republishing.